Sonata V6-3.3L (2006)
Front Door Panel: Adjustments
ADJUSTMENT
GLASS ADJUSTMENT
NOTE: Check the glass run channel for damage or deterioration, and replace them if necessary
1. Remove the following parts.
-
Quadrant cover.
-
Door trim.
2. Carefully move the glass (A) until you can see the glass mounting bolts(B), then loosen them.
3. Push the glass (A) against the channel, then tighten the glass mounting bolts.
4. Check that the glass moves smoothly.
5. Raise the glass fully, and check for gaps. Check that the glass contacts the glass run channel evenly.
6. Check for water leaks. Run water over the roof and on the sealing area as shown, and note these items:
-
Use a 12mm (1/2lin.) diameter hose (A).
-
Adjust the rate of water flow as shown (B).
-
Do not use a nozzle.
-
Hold the hose about 300mm(12in.) away from the door (C).
DOOR STRIKER ADJUSTMENT
Make sure the door latches securely without slamming it. If necessary, adjust the striker (A): The strike nuts are fixed. The strike can be fine adjusted up
or down, and in or out.
