hyundai Workshop Repair Guides

Hyundai Workshop Service and Repair Manuals

Sunroof / Moonroof Motor|Testing and Inspection|Page 11574 > < Sunroof / Moonroof Module|Locations
Page 1
background image

Sunroof / Moonroof Motor: Testing and Inspection

INSPECTION

1. Disconnect the negative (-) battery terminal.

2. Apply the battery voltage to terminal 3,6 and ground the terminal 1.

3. Ground the terminals as below table, and check that the sunroof unit operates as below table.

4. Make these input tests at the connector

If any test indicates a problem, find and correct the cause, then recheck the system.
If all the input tests prove OK, the sunroof motor must be faulty; replace it.

RESETTING THE SUNROOF

Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the sunroof, you have to reset your sunroof
system as follows

1. Turn the ignition key to the ON position.
2. According to the position of the sunroof, do as follows.

1. In case that the sunroof has closed completely or been tilted: Press the TILT UP button until the sunroof has tilted upward completely.
2. In case that the sunroof has slide-opened: Press and hold the CLOSE button for more than 5 seconds until the sunroof has closed completely.

Press and hold the CLOSE button for more than 5 seconds after the sunroof has closed completely. Press the TILT UP button until the sunroof
has tilted upward completely.

Sunroof / Moonroof Motor|Testing and Inspection|Page 11574 > < Sunroof / Moonroof Module|Locations