Sonata V6-3.3L (2006)
If you are reusing the pads, always reinstall the brake pads in their original position to prevent a momentary loss of braking efficiency.
5. Push in the piston (A) so that the caliper will fit over the pads. Make sure that the piston boot is in position to prevent damaging it when pivoting
the caliper down.
6. Pivot caliper down into position. Being careful not to damage the pin boot, install the guide rod bolt (B) and torque it to proper specification
NOTE: Insert the piston in the cylinder using the special tool (09581-11000).
7. Depress the brake pedal several time to make sure the brakes work, then test-drive.
NOTE: Engagement of the brake may require a greater pedal stroke immediately after the pads have been replaced as a set. Several applications
of the brake will restore the normal pedal stroke.
8. After installation check for leaks at hose and line joints or connections, and retighten if necessary.
