Sonata V6-3.3L (2006)
4.
Do not turn the ignition key OFF during reprogramming.
5.
When the reprogramming is completed, wait for about 20 seconds and then start the engine to confirm proper operation of the vehicle.
ESC ECU REPROGRAMMING:
NOTE:
Verify that the vehicle was manufactured within the affected production date range and the campaign is open per the DCS interactive screen.
1.
Attach the Data Link Connector (DLC) cable to the Hi-Scan Pro main body and securely tighten the two bolts.
2.
Remove the system software card from the Hi-Scan Pro and insert the reprogramming software card with the new ECU program into the Hi-Scan
top slot.
3.
Plug the DLC cable from the Hi-Scan Pro into the data link connector (16-pin connector) under the instrument panel on the driver's side.
4.
Turn the ignition switch to the ON position. (Do not start the engine).
5.
Turn the Hi-Scan Pro ON and press ENTER.
6.
Select option "61. SONATA ESP LOGIC IMPROVEMENT" and press ENTER.
7.
Select option "01. SONATA ESP LOGIC [AUTO MODE]" and press ENTER.
8.
Enter "1229" as the password for automatic reprogramming mode and press ENTER.
9.
The Hi-Scan Pro will establish communication, check the ESC ECU ID and reprogram the ESC ECU automatically.
CAUTION:
IF "ALREADY REPROGRAMMED. PRESS ANY KEY" is displayed on the Hi-Scan Pro screen in step 9, exit the ESC ECU reprogramming
procedure by pressing any key. The ESC ECU reprogramming has previously been completed on this vehicle.
