Sonata V6-3.3L (2006)
Hazard Warning Flasher: Testing and Inspection
INSPECTION
1. Disconnect the negative (-) battery terminal.
2. Disconnect the hood release cable from the hood release handle.
3. Remove the crash pad side cover (A).
4. Remove the flasher unit (A) after loosening the nut and disconnecting the connector.
5. Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 3.
6. Connect the two turn signal lamps in parallel to terminals 1 and 3 Check that the bulbs turn on and off.
NOTE: The turn signal lamps should flash 60 to 120 times per minute. If one of the front or rear turn signal lamps has an open circuit, the
number of flashes will be more than 120 per minute. If operation is not as specified, replace the flasher unit.
