Sonata V6-3.3L (2006)
Route the cable over the steering column to ensure the cable does not become disconnected.
AUTOMATIC REPROGRAMMING
PROCEDURE:
1.
Turn the ignition switch to the ON position. (Do not start the engine)
2.
Turn the Hi-Scan Pro ON and press ENTER.
3.
Select option "70. NF 3.3 DRIVING FEEL IMPROVEMENT" and press ENTER.
4.
Select option "01. NF 3.3 DRIVING FEEL [AUTO]" and press ENTER.
5.
Enter "1229" as the password for automatic reprogramming mode and press ENTER.
6.
The Hi-Scan Pro will establish communication, check the PCM ID, and reprogram the PCM automatically.
NOTE:
^
The Hi-Scan Pro detects the current PCM ID, assigns the new PCM ID and displays them on the Hi-Scan Pro screen.
^
Check the PCM ID displayed on the Hi-Scan Pro screen to verify that the correct PCM software is being downloaded
(NF5N33*S2AS5E1BC).
WARNING:
Do not interrupt the reprogramming at any time.
^
If the Hi-Scan Pro does not download the program, use the "MANUAL REPROGRAMMING PROCEDURE" following this section.
7.
When "REPROGRAMMING COMPLETED" message is displayed, turn the Hi-Scan Pro OFF.
8.
Turn the ignition key OFF for about 20 seconds and start the engine to confirm proper operation of the vehicle.
9.
Check for diagnostic trouble codes using the Hi-Scan Pro with the system software card and erase any trouble codes.
MANUAL REPROGRAMMING PROCEDURE:
1.
Turn the ignition switch to the OFF position.
