Sonata V6-3.3L (2006)
^ Do not turn off the ignition switch during update.
GDS INSTALLATION PROCEDURE:
1. Connect the power supply cable to the diagnostic terminal.
NOTE:
If attempting to perform the update with the power supply cable disconnected from the diagnostic terminal, make certain that the diagnostic terminal is
charged enough for the update. If not, the update may fail in progress. Therefore, it is strongly recommended to connect the power supply cable to the
diagnostic terminal during the update procedure.
2. Connect the USB cable between the VCI and the diagnostic terminal.
NOTE:
When performing the update using the GDS, wireless communication between the VCI and the diagnostic terminal is NOT available. Therefore, be sure
to connect the USB cable between the VCI and the diagnostic terminal.
3. Connect the 16-pin DLC cable from the VCI into the vehicle's 16-pin connector under the driver side instrument panel.
4. Turn on the VCI and diagnostic terminal with the ignition key in the ON position.
NOTE:
Do not start the engine.
AUTOMATIC UPDATE PROCEDURE USING THE GDS:
1. Choose VIN or ECU Upgrade on the initial screen.
