Sonata V6-3.3L (2006)
4.
Remove the 2 bolts (E) and disengage the lower arm ball joint from the knuckle. Lower arm ball joint to knuckle nut torque: 10~12kgf-m (74~88
lb-ft)
5.
Disengage the driveshaft from the front hub using a plastic hammer.
6.
Remove any foreign material from the contact surface between the front hub (F) and the driveshaft (C) and then wipe it gently with a clean cloth.
7.
Clean the isolation washer and apply grease to 2 points on one surface of the washer as shown in the photo.
[NOTE]
Be careful not to apply an excessive amount of grease. The grease is used to prevent the washer from moving freely during installation of the
driveshaft to the front hub.
