Sonata GL V6-2.5L (1999)
CAUTION: Be careful not to depress the brake pedal while disassembling the pads.
INSPECTION
1. Check the pads for wear or oil contamination. Replace or correct if necessary.
2. Check the shims for damaged or deformed.
INSTALLATION
1. Install the pad clips.
2. Install the pads onto each pad clip.
NOTE:
1. All four pads must be replaced as a complete set.
2. Position the pad with its pad wear sensor to the piston side and to the upward.
3. Remove rust before position the pad clip or replace new one if it is damaged.
3. Press in piston with a hammer handle or equivalent.
4. Lower and insert the brake cylinder carefully so as not to damage the boot.
5. Install the two guide rod bolts and tighten.
Guide rod bolt: 22 - 32 Nm (220 - 320 kg.cm, 16 - 24 ft. lbs.)
