Sonata GL V6-2.5L (1999)
Crankshaft sprocket --> Idler pulley --> Intake cam sprocket (LH side) --> Power steering pump pulley --> Intake cam sprocket (RH side) -->
Tensioner pulley.
NOTE:
-
In this step, No. 1 is in TDC (Compression stroke)
-
Do not insert fingers.
7. Pull out the set pin of auto tensioner.
8. Install the engine mount bracket from the engine.
9. Install the engine mounting insulator.
10. Install the upper and lower timing belt covers.
11. Install the power steering pump pulley, idler pulley, tensioner pulley and crankshaft pulley.
12. Using the spanner [16mm], rotate the tensioner arm clockwise (about 14°) and Install the belt from pulley.
13. Install the engine cover.
The method to adjust the tension of timing belt.
1. Rotate the crankshaft 2 rotation clockwise and measure the projected load of auto tensioner in the TDC (# 1 Compression stroke) after 5 minutes.
2. Check the projected length is 6-8 mm.
3. Check again if the timing marks of each sprocket is with in specified position.
NOTE: If not within specified position, do again from procedure 6 in the method of installing Timing belt and auto tensioner.
