Sonata GL V6-2.5L (1999)
14.
Reconnect any additional wires disconnected during seat removal.
15.
Lower the seat into its mounting position.
16.
Now perform the driver's seat procedure if it has not already been completed.
Re-Install Both Front Seats
1.
Re-install the seats into position. Lightly tighten the four mounting nuts and bolts.
2.
Verify the seat slides forward and backward, locking into place when the seat track handle is released. If necessary, loosen all 4 fasteners, slide the
seat front and back a few times, then latch the tracks in place.
3.
Tighten the four fasteners to the appropriate torque values and recheck the seat operation. Repeat step 2 if necessary.
4.
Reconnect the battery negative terminal. Turn the ignition key ON. Reset the customers radio station presets. Set the clock to the correct time.
5.
Use the Hi-Scan Pro to erase any diagnostic trouble codes. Disconnect the Hi-Scan Pro and check that the airbag light flashes 6 times then turns
off. If the light does not do this, diagnose the system as per TSB 00-90-008.
