Sonata GL V6-3.0L (1997)
reassembly.
-
Note alignment arrows of rocker arm assemblies.
INSTALLATION
1. Dip the auto lash adjuster in clean, pure diesel fuel.
2. While using a small wire to lightly press the check ball downward, move the plunger up and down four or five times to bleed out the air.
3. Install camshaft in the cylinder head after applying a coat of engine oil to the camshaft journal and cams.
4. Insert the auto lash adjusters, being careful not to spill the diesel oil inside them. Then, use the clip tool to prevent the adjusters from falling out
while installing.
5. Apply a minimum amount of sealing agent Threebond No. 1324, or equivalent, on the four places shown in the illustration.
NOTE: Ensure that the sealing agent does not leak out onto the cam journal surface of the cylinder head. If it does, wipe it off before it dries.
6. Install the rocker arm shaft assemblies (A) and (B) such that the arrow mark on the bearing cap faces in the same direction as the arrow mark on
the cylinder head.
NOTE: The arrow marks face each other on rocker arm shaft assemblies (A) and (B).
7. Tighten the bearing cap bolt to 19-21 Nm (190-210 kg. cm, 14-15 ft. lbs.), then remove the clip tool attached in auto lash adjuster.
