Sonata GL V6-3.0L (1997)
1. Clean the pulley bearing surface of the compressor head to remove any dirt or corrosion.
2. Install the pulley and bearing assembly on the compressor. The bearing is a slip fit on the compressor head and, if properly aligned, should slip
smoothly on the compressor head.
3. Install the pulley retaining snap ring with the bevel side of the snap ring out.
4. Place one normal thickness spacer shim inside the hub spline opening and slide the hub on the end of the compressor shaft.
5. Thread anew hub retaining bolt into the end of the compressor shaft. Tighten the hub retaining bolt.
Tightening torque: 10-15 Nm (100-150 kg.cm, 7-11 lb.ft)
NOTE: Do not use air tools.
