Sonata GL V6-3.0L (1997)
Distributor: Service and Repair
Disassembly and Reassembly
DISASSEMBLY
1. Lightly clamp the distributor in a vise equipped with soft jaws.
2. Remove the rotor installation screw and pull off the rotor from the rotor shaft
3. Remove the rotor shaft mounting screw.
4. Remove the shaft bearing tightening screws.
5. Place the drive gear on a soft base (wooden block) so that the spring pin can be removed
6. Remove the spring pin using removed punch.
REASSEMBLY
SHAFT
After coating the shaft with a small amount of engine oil, insert it into the housing.
CAUTION: Do not use solvent or similar products.
DRIVE GEAR
1. Mount the gear on the shaft, aligning it with the mating mark.
