Sonata GL V6-3.0L (1997)
Transmission Position Switch/Sensor: Adjustments
1. Place the selector lever in the "N" (Neutral) position.
2. Loosen the control cable to the manual control lever. Separate the cable and lever.
3. Place the manual control lever in the "N" (Neutral) position.
4. Rotate and adjust the park/neutral position switch body so the hole in the end of the manual control lever and the hole (cross section A-A in the
figure) in the flange of the park/neutral position switch body are aligned.
5. Tighten the attaching bolts (2 pcs.) carefully so that the switch body does not move.
6. Make sure that the selector lever is in the "N" (Neutral) position.
7. Remove any slack in the control cable by adjusting the nut and then check that the selector lever moves smoothly.
8. Check that the control cable has been adjusted correctly.
