Sonata GL V6-3.0L (1997)
2. Remove the rear cover with the gasket and pins.
3. Remove the cam ring.
4. Remove the rotor and vanes.
5. Remove the front side plate.
6. Remove the inner and outer O-ring.
7. Remove the spring.
NOTE: When assembling, use a new gasket and O-ring.
8. Remove the pulley nut and the spring washer.
9. Pull off the pulley and the woodruff key.
10. Remove the snap ring using the snap ring pliers.
11. Drive out the pulley shaft and bearing. If necessary, use a plastic hammer.
