Sonata GL V6-3.0L (1997)
Band Apply Servo: Adjustments
1. Remove dust, dirt, and other contaminants completely from Kickdown (K/D) servo cover and surrounding areas.
2. Snap off the snap ring and remove K/D servo switch.
3. Fit claw of special tool into cutout in piston to prevent piston from turning and use adapter to fix the piston into position.
CAUTION:
a. Do not push piston with the special tool.
b. Secure adapter only hand-tight to L/R brake pressure take-up port and do not apply excessive torque.
4. Loosen lock nut to immediately before V-groove in adjust rod and tighten special tool (09454-33101B) or equivalent, until it contacts lock nut.
5. Fit special tool (09454-33101A) or equivalent, over the lock nut. Turn K/D servo socket wrench A counterclockwise and turn inner cylinder
clockwise to lock the lock nut and special tool K/D servo socket wrench B (09454-33101B) or equivalent.
6. Fit torque wrench to special tool (09454-33101B) or equivalent, and repeat tightening and lessening cycle two times with a torque of 10 Nm
(86.40 inch lbs.) Then, torque to 5 Nm (43.20 inch lbs.) Next, back off special tool (09454-33101B) or equivalent, 2 to 2 1/4 turns.
