Sonata GL V6-3.0L (1997)
Clutch: Service and Repair
Front Clutch Assembly
NOTE: To remove and install this component from transaxle see overhaul procedure of automatic transaxle. See: Service and Repair
DISASSEMBLY
1. Remove snap ring from clutch retainer.
2. Take out the four clutch reaction plates and three clutch discs. If the clutch reaction plates and the clutch discs are to be reused, be sure not to
change the installation order or direction.
3. With the return spring compressed using special tool (09453 - 21000, 09453 - 24000) or equivalents, remove the snap ring, then the spring retainer
and return spring.
4. Remove the piston from the retainer.
5. Remove the D-rings from the inner and outer circumferences of the piston.
INSPECTION