Sonata GL V6-3.0L (1997)
4. Remove one pinion shaft from any of the short pinions.
5. Remove the spacer bushing and the two front thrust washers.
6. Remove only one short pinion. Use care not to drop and lose any of the 17 rollers in the short pinion.
7. Push the one-way clutch out of the outer race with your fingers.
ASSEMBLY
1. Apply a generous amount of petroleum grease to the inside diameter of the short pinion to hold the 17 rollers in place.
2. Line up the holes in the rear thrust washer and front thrust washer with the shaft of the carrier.
3. Install the short pinion, spacer bushing and two front thrust washers and align the holes. Use care not to allow the rollers to move out of position.
4. Insert the pinion shaft. Be sure that the flattened end of the pinion shaft fits properly into the hole in the rear thrust plate when the pinion shaft is
inserted.
