Sonata GLS V6-2.5L (2000)
17.
Repeat the procedure for the other seat.
Type 2 - Drivers And Passenger Seat
DRIVER'S SEAT
NOTES:
^
This procedure applies to the driver's seat only.
^
Be sure that the passenger's seat procedure is also performed.
1.
The ignition key should already be off and the battery negative terminal should already be removed before continuing. Tilt the seat back as shown
in the photo, disconnect the SAB module connector and remove the wire tie from the front of the seat frame. Detach any other wiring as necessary
and tilt the seat back far enough to be able to work under it.
NOTE
If you need additional room to work on the underside of the seat, simply remove the headrest and turn the seat upside down over the rear seat.
2.
Remove and disc&d the existing connector clip. Install the new connector clip (4) to the seat frame using the existing hole.
