Sonata GLS V6-2.7L (2002)
Parking Brake Lever: Service and Repair
REMOVAL
1. Remove the main floor console.
2. Detach the parking brake switch.
3. Remove the parking brake lever.
4. Remove the parking brake lever from the parking brake cable.
5. Remove the rear seat cushion and take up the carpet.
6. Remove the parking brake cable clamp and grommet.
7. Move the center muffler heat protector center panel to the front.
8. Remove the washer assembled bolt and detach the clamp bracket.
9. Remove the wheel assembly and the brake drum.
10. Remove the rear hub assembly.
11. Remove the springs and shoe hold down pins.
12. Remove the cable clip.
13. Disconnect the cable end from the trailing shoe.
14. Drive out the parking brake cable to the under body side.
INSPECTION
1. Check the parking brake switch operation.
2. Check the parking brake lever ratchet for wear.
3. Check the parking brake cable for operation or damage.
INSTALLATION