Sonata GLS V6-2.7L (2002)
B.
If the vehicle is equipped with ABS, the B1/S2 02 Sensor Wiring routing is not visible from the top. Lift the vehicle and examine the 02
Sensor wiring from below the vehicle. The pictures show the correct and incorrect wiring routing when viewed from below the vehicle.
If the sensor wire was routed incorrectly as shown, correct the wire routing by following the procedure in this TSB.
3.
Write down the radio preset stations (AM, FM1 and FM2).
4.
Remove the negative (-) battery cable
5.
Route the sensor wire correctly by performing the following steps:
NOTE:
The directions below are for a vehicle equipped with ABS. If the vehicle is NOT equipped with ABS, these steps may be performed from
above the vehicle.
A.
Remove the plastic cover near the B1/52 02 sensor (10 mm socket, 2 bolts).
B.
Remove the cap from the generator "B" terminal by using a right angle pick tool.
