Sonata GLS V6-2.7L (2002)
6.
Use electrical tape to tape the end of the corrugated tube to the end of the air bag floor wire harness connector. Push the tube up against the
connector and wrap the tape first around the bottom of the connector, then around the end of the tube. Wrap about 3 layers, going at least one inch
down the tube.
7.
Repeat the same taping procedure for the PPD floor wire harness.
8.
Install the new connector clip (4) into the seat frame. Insert the air bag connector into the clip.
9.
Determine whether the seat has an oval mounting hole to the right of the connector clip. If so, proceed to step 11. If not, drill a hole in step 10.
