Sonata GLS V6-2.7L (2002)
CAUTION: Do not apply the vehicle weight to the wheel bearing while the driveshaft is disconnected If the vehicle's weight must be applied
(because of vehicle movement or some other reason), use the special toot to hold the wheel bearing, as shown in the figure.
9. After releasing the auto tensioner, remove the drive belt. (2.7L ENG.)
10. Remove the alternator assembly (2.7L ENG.)
11. Remove the center bearing bracket mounting bolts. Insert the pry bar between the center bearing bracket and the cylinder block to disconnect the
bracket from the cylinder block.
12. Remove the inner shaft from the transaxle.
13. Using the special tool (09432-11000), remove the tone wheel.
INSPECTION
1. Check the driveshaft boots for damage and deterioration.
2. Check the ball joints for wear and damage.
3. Check the splines for wear and damage.
