Tiburon L4-1.8L (1997)
3. Remove the caliper assembly mounting bolts (2EA).
4. Remove the brake pad and caliper assembly.
5. Remove the parking cable after disconnecting the parking cable mounting clip.
INSPECTION
1. Check the pads for wear or oil contamination and replace if necessary.
NOTE: The pads for the right and left wheels should be replaced at the same time
Pad thickness wear limit: 0.8 mm (0.315 inch)
2. Check the leading and trailing shoe keys and retaining screw for damage, or wear. Replace the keys and retaining screw at the same time the pads
are replaced.
3. Check for worn or damaged dust boots if dust or mud has entered the caliper assembly through this seal, the caliper assembly must be replaced or
rebuilt.
INSTALLATION
NOTE: Before replacing the brake pads, remove brake fluid from the master cylinder reservoir until it is half full.
1. Check for worn, damaged, or rusted piston bore and piston. Replace the damaged parts if necessary.
2. Check for damaged piston seal, boot, and pin insulators.
