Tiburon L4-1.8L (1997)
Brake Rotor/Disc: Service and Repair
Front
REMOVAL
1. Remove the drive shaft nut.
2. Jack up the vehicle and support it with jack stands.
3. Remove the wheel and tire.
4. Remove the front wheel brake assembly from the knuckle and suspend it with a wire.
NOTE: Brake hose does not need to be disconnected from brake caliper. Be careful not do depress brake pedal, or piston will pop out.
5. Disconnect the lower arm ball joint from the knuckle using the Special Tool (09568-34000).
6. Remove the wheel speed sensor mounting bolt and wire clamp and then remove the wheel speed sensor (For ABS vehicle only).
7. Disconnect the tie rod end ball joint from the knuckle using the Special tool.
NOTE:
1. Be sure to tie the cord of the special tool to the nearby part.
2. Loosen the nut, but do not remove it.
8. Disconnect the drive shaft from the hub using the special tool 09526-11001.
