Tiburon L4-1.8L (1997)
9. Remove the hub and knuckle as an assembly from the strut.
INSPECTION
1. Check the hub for cracks and the splines for wear.
2. Check the snap ring for cracking or damage.
3. Check the brake disc for scoring and damage.
4. Check the steering knuckle for cracks.
5. Check for a defective bearing.
INSTALLATION
1. Install parts to torque specifications.
2. Be sure to install the washer and wheel bearing nut in the specified direction.
3. After installing the wheel, lower the vehicle to the ground and tighten the wheel bearing nut.
4. If the position of the split pin holes do not match, tighten the nut up to 260 Nm (2600 kg.cm, 188 ft. lbs.) maximum.
5. Install the split pin in the first matching holes and bend it over.
