Tiburon L4-1.8L (1997)
15.
Install the water pump tube at the back of the water pump. Apply a thin film of Lubriplate 105 or equivalent to the O-ring before installing the
tube. Reinstall the bolt at the hose end of the tube.
Note: Always replace the O-ring when removing the pipe assembly. O-ring part no. 25462-23000.
16.
Reinstall the exhaust manifold [torque the nuts to 35 lb.ft (47 Nm)]. Reinstall the heat shield, the power steering pump/bracket and the engine
compartment lower plastic splash guard.
17.
Route the wiring of the block heater towards the oil filter and tie wrap it to the engine block. Route the wiring along/around the wiring harness to
the alternator.
18.
Route the block heater wiring back up toward the lower opening of the front bumper.
19.
Tie wrap the rest of the block heater wiring to the cross bars on the lower opening of the front bumper, making sure that the plug will be easily
accessible yet not so loose as to cause damage to the front bumper when the vehicle is driven.
20.
Refill the radiator/reservoir with the proper mix of coolant and water. Make sure that the system is fully filled. Start the engine and check for any
coolant leak.
