Tiburon L4-1.8L (1997)
INSTALLATION
NOTE:
-
Clean each part before assembly.
-
Apply engine oil to sliding and rotating parts.
1. After installing the spring seat, fit the stem seal onto the valve guide.
2. Fit valve stem oil seal installer tool No. 09222-22000, or equivalent, to the seal then drive seal into position by lightly tapping the installer tool as
shown in the illustration.
CAUTION:
-
The seal is installed in the specified position by means of the special tool.
-
Incorrect installation of the seal will adversely affect the lip I.D. and eccentricity, resulting in oil leaking down the valve guides.
-
Therefore, when installing, be careful not to twist the seal. Do not reuse old stem seals.
3. Install remaining valve and spring components.
