Tiburon L4-1.8L (1997)
ACTUATOR INSPECTION
1. Disconnect the connector at the idle speed control actuator.
2. Measure the resistance between terminals.
Standard value:
Terminal 1 and 2: 10.5 - 14 Ohms
Terminal 2 and 3: 10 - 12.5 Ohms [at 20°C (68°F)]
3. Connect the connector at the idle speed control actuator.
TROUBLESHOOTING PROCEDURES:
DTC P1510, P1513, P1552, P1553 - Idle Speed Control (ISC) Actuator
TROUBLESHOOTING HINTS
Open or short circuit is observed in idle air control system when ignition switch is turned on.
