Tiburon L4-1.8L (1997)
Transmission Position Switch/Sensor: Adjustments
1. Place the selector lever in the "N" (Neutral) position.
2. Loosen the manual control lever lock nut to separate the cable and lever.
3. Place the manual control lever in the "N" (Neutral) position.
4. Turn the transaxle range switch body until the 12 mm (0.47 inch) wide end of the manual control lever aligns with the switch body flange [12 mm
(0.47 inch) wide portion].
5. Tighten the attaching bolts (2 pcs.) to the specified torque.
Tightening torque:
Transaxle Range Switch Attaching Bolt: 10-12 Nm (84-108 inch lbs.).
NOTE: When setting up the switch body, be careful O-ring not to drop from the switch body. Tighten the attaching bolts carefully.
6. Make sure that the selector lever is in the "N" (Neutral) position.
7. Adjust the flange nut so that there is no slack in the control cable and make sure that the selector lever operates smoothly.
8. Run the vehicle and confirm that the transaxle is set in each range when the selector lever is shifted to each position.
