Tiburon L4-1.8L (1997)
CAUTION: Always use a new nut.
19. Apply semi-drying sealant to the threaded section of the end plug and tighten to 50-70 Nm (37-52 ft. lbs.).
20. Stake the end plug at two points on its circumference with a punch.
21. Install the bushing, rack support yoke, rack support spring and yoke plug in the order shown. Apply semi-drying sealant to the threaded section of
the yoke plug before installation.
22. With the rack placed in the center position, attach the yoke plug to the gear housing. Tighten the yoke plug to 15 Nm (11 ft. lbs.), using the special
tool. Loosen the yoke plug approximately 30 to 60°,and tighten the locking nut to 50-70 Nm (37-52 ft. lbs.).
23. Tighten the feed tube to the specified torque and install the mounting rubber using adhesive.
24. Apply the specified grease, Silicone grease to the bellows mounting position (fitting groove) of the tie rod.
25. Install the attaching band to the bellows.
NOTE: When the bellows are installed, a new band must be used.
26. Install the bellows in position, taking care not to twist it.
