Tiburon L4-1.8L (1997)
Control Arm Bushing: Service and Repair
Front Upper Control Arm Bushing
1. Install the Special Service Tool (SST) (09545-34000, 09545-28100) on the lower arm.
2. Press out the bushing.
3. Apply soap solution to following portions.
a. Outer surface of the new bushing.
b. Inner surface of the lower arm bushing mount.
c. Inner surface of the Special Tools.
4. Install the Special Tools and new bushing onto the lower arm.
5. Press fit the bushing into the lower arm bushing mount.
6. Center the bushing by the following procedure, if necessary.
-
Reset the Special Tools and lower arm.
-
Center the bushing.
NOTE: After centering the bushing, wipe off the soap solution.
