Tiburon L4-1.8L (1997)
9. Press-in the bearing by using the special tool.
NOTE: Do not press inner race of wheel bearing assembly.
10. Install snap ring into groove of knuckle.
11. Install the disc to the hub. and torque to specification.
Tightening torque: 50 - 60 Nm (500 - 600 kg.cm, 36 - 43 ft. lbs.)
12. Use the special tool to mount the hub onto the knuckle.
13. Tighten the hub to the knuckle to 200 - 260 Nm (2000 - 2600 kg.cm, 148 - 192 ft. lbs.) with the special tool.
14. Rotate the hub to seat the bearing.
15. Measure the hub bearing starting torque.
Hub bearing starting torque [Limit]: 1.3 Nm (13 kg.cm, 11 inch lbs.) or less.
16. If the starting torque is 0 Nm (0 inch lbs.), measure the hub bearing axial play.
17. If the hub axial play exceeds the limit while the nut is tightened to 200 - 260 Nm (2,000 - 2,600 kg.cm, 148 - 192 ft. lbs.), the bearing, hub and
knuckle have not been installed correctly. Repeat the disassembly and assembly procedure.
Hub bearing axial play [Limit]: 0.008 mm (0.0003 inch) or less.
18. Remove the special tool.
