Tiburon L4-1.8L (1997)
Band Apply Servo: Adjustments
1. Completely remove all dirt and other contaminating materials adhered around the kick down adjusting screw.
2. Loosen the lock nut and turn the adjusting screw end of it.
3. Loosen and tighten the adjusting screw two times, and then finish tightening the adjusting screw at a torque of 5 Nm (86.4 inch lbs.).
4. Loosen again the adjusting screw 3 to 3-1/3 turns.
5. While holding with 7 mm wrench socket so that the adjusting screw won't turn, tighten the lock nut to the specified torque.
Tightening torque:
Lock nut: 15-22 Nm (11-16 ft. lbs.).
NOTE: Before assembling, apply sealant (DC780 or equivalent) to the center portion of the adjusting screw.
