Tiburon L4-1.8L (1997)
5. Install the four clutch reaction plates and three clutch discs. Prior to installation, apply automatic transaxle fluid to them.
CAUTION: When new clutch discs are used, they should be immersed in automatic transaxle fluid a minimum of two hours prior to installation.
6. After installing the snap ring, check to see if there is a 0.7-0.9 mm (0.028-0.035 inch) clearance between the snap ring and the clutch reaction
plate.
7. To check clearance, hold the entire circumference of the clutch reaction plate down with 50 N (11 lbs.) force. If clearance is out of specification,
adjust the clearance by selecting the proper snap ring.
