Tiburon L4-1.8L (1997)
3. Line up holes in the rear thrust washer and front thrust washer with shaft of carrier.
4. Install short pinion, spacer bushing and two front thrust washers and align the holes. Use care not to allow rollers to move out of position.
5. Insert the pinion shaft. Be sure that flattened end of the pinion shaft fits properly into the hole in the rear thrust plate when pinion shaft is inserted.
6. Install end plate in the outer race.
7. Press the overrunning clutch into outer race. Be sure that the arrow on the outside circumference of the cage is pointing upward as shown in the
illustration when the overrunning clutch is installed.
8. Apply petroleum jelly to the overrunning clutch end plate to retain it inside the overrunning clutch. Install the end plate in the clutch.
