Tiburon L4-1.8L (1997)
Limit: 0.5 mm (0.02 inch).
Synchronizer Sleeve And Hub
1. Install the synchronizer sleeve on the hub and check that it slides smoothly.
2. Check that the sleeve is free from damage.
3. Check for wear of the hub end surfaces (in contact with each gear).
CAUTION: Replace the synchronizer hub and sleeve as a set.
Synchronizer Key And Spring
1. Check for wear of the synchronizer key center protrusion.
2. Check the spring for weakness, distortion or damage.
Gears
1. Check the helical gear and clutch gear teeth for damage or wear.
2. Check the gear cone for rough surfaces, damage or wear.
3. Check the gear bore for damage or wear.
ASSEMBLY
1. Install the first speed gear assembly with needle bearing.