Tiburon L4-2.0L (1999)
NOTE: The pads for the right and left wheels should be replaced at the same time.
Pad thickness wear limit 2.0 mm
2. Check the leading and trailing shoe keys and retaining screw for damage, or wear. Replace the keys and retaining screw at the same time the pads
are replaced.
3. Check for worn or damaged dust boots if dust or mud has entered the caliper assembly through this seal, the caliper assembly must be replaced or
rebuilt.
4. Before replacing the brake pads, remove brake fluid from the master cylinder reservoir until it is half full.
ASSEMBLY
1. Check for worn, damaged, or rusted piston bore and piston. Replace the damaged parts if necessary.
2. Check for damaged piston seal, boot, and pin insulators.
3. Apply a recommended lubricant to the following parts
4. Push the piston into the caliper with special tool.
