Tiburon L4-2.0L (1999)
3. Install the pulley retaining snap ring with the bevel side of the snap ring out.
4. Place one nominal thickness spacer shim inside the hub spline opening and slide the hub on the end of the compressor shaft.
5. Thread a new hub retaining bolt into the end of the compressor shaft. Tighten the hub retaining bolt.
Tightening torque : 10.2 - 15.3 Nm (102 - 153 kg.cm, 7.5 - 11.3 lb.ft)
NOTE: Do not use air tools.
6. Check the clutch air gap between the clutch hub and the pulley mating surfaces with a feeler gauge. The air gap should be as follows:
Standard : 0.35 - 0.65 mm (0.014 - 0.026 in.)
Check at three locations equally spaced around the pulley.
7. If the clutch air gap is not within the dimensions specified above, repeat steps 4 through 6 with the various thickness shims until the air gap is
between the specified limits.
