Tiburon L4-2.0L (1999)
Wheel Bearing: Testing and Inspection
WHEEL BEARING END PLAY INSPECTION
1. Inspect the play of the bearing while the vehicle is jacked up and resting on floor jack.
2. If there is any play, remove the hub cap and then release the parking brake.
3. Check the bearing end play. Place a dial gauge against the hub surface, then move the hub in the axial direction and check whether or not there is
end play.
Service limit mm (in.): 0.005 - 0.025 (0.0002 - 0.001) or less
4. If the end play exceeds the limit, the rear wheel bearing nut should be tightened to the specified torque and check the end play again.
5. Replace the rear hub bearing unit if an adjustment cannot be made to within the limit.
