hyundai Workshop Repair Guides

Hyundai Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 3953 > < Diagram Information and Instructions|Page 3951
Page 6
background image

TROUBLESHOOTING HINTS

When the lean/rich period is above 2.6 seconds in the condition that fully warm-up engine is 2,000 - 3,000 rpm and engine is above middle load.

TROUBLESHOOTING HINTS

1. If the heated oxygen sensor is defective abnormally, high emissions may occur.
2. If the heated oxygen sensor check has been normal, but the sensor output voltage is out of specification, check the following items related to the air

fuel ratio control system.
-

Faulty injector.

-

Air leaks in the intake manifold.

-

Faulty mass air flow sensor, EVAP valve and engine coolant temperature sensor.

-

Wiring connection problem.

3. When 02 sensor output voltage is maintained as following for above 50 seconds.

-

Upstream 0.4 V - 0.6 V

-

Downstream : 0.4 V - 0.5 V

USING VOLTMETER

NOTE:  If you release the accelerator pedal suddenly with the engine running about 4000 rpm, the fuel supply will be stopped for a while. When you
suddenly press the accelerator pedal, the voltage will reach 'B' range. Then, when you let the engine idle again, the voltage fluctuates between 'A' and
'B' range. In this case, the O2 sensor can be determined as good.

Diagram Information and Instructions|Page 3953 > < Diagram Information and Instructions|Page 3951