Tiburon L4-2.0L (1999)
8. Remove the pulley nut, then remove the spring washer, then the pulley, and then the spacer.
9. Remove the front bracket and seals.
10. Remove the rotor from the vise.
11. When separating the rectifier from the brush holder, unsolder the two plates soldered to the rectifier.
REASSEMBLY
Perform reassembly in the reverse procedure of disassembly. Pay attention to the following:
Before the rotor is attached to the rear bracket, insert a wire through the small hole in the rear bracket to lock the brushes. After the rotor has been
installed, the wire can be removed.
