Tucson AWD L4-2.0L (2007)
Trunk / Liftgate Latch: Service and Repair
Actuator Assembly
ACTUATOR ASSEMBLY
1. Remove the tailgate trim.
2. Disconnect the outside handle rod (A), actuator rod (B), glass latch rod (C), key cylinder rod (D) and connector.
3. After loosening the mounting bolt and nuts, then remove the actuator assembly (E).
4. Installation is the reverse of removal.
NOTE:
-
Make sure the connector is connected properly and the connecting rod is connected properly.
-
Make sure the tailgate opens properly and locks securely.
