Tucson AWD L4-2.0L (2007)
Tire Pressure Module: Service and Repair
TPMS RECEIVER
REPLACEMENT
NOTE: When the receiver first arrives for replacement:
a. It will be in Virgin State.
b. It will not be configured for any specific platform.
c. It will not have any sensor IDs memorized.
CAUTION: It is important to make sure that the correct receiver is used to replace the faulty part i.e. it must be Low Line (PN 95800-2E500) and
not High Line (PN 95800-26000) in order to have the correct inflation warning thresholds set.
1. Disconnect vehicle battery.
2. Remove faulty part and fit bracket assembly to new part.
3. Secure new part to vehicle and fit connector.
4. Re-connect battery and turn Ignition on.
5. Check that DTC flash rate matches Virgin State indication.
6. Connect "TPMS exciter" to the diagnostic connector.
