Tucson AWD L4-2.0L (2007)
10.
To identify that the air bag cover module has been replaced, and that the inflator mounting nuts have the correct tightening torque, mark all four
inflator mounting nuts with a paint pen.
11.
Reconnect the two squib connectors and secure the squib wiring harness in the retaining clip. Install the new air bag module to the steering wheel
in the reverse order of removal. Torque the air bag module mounting bolts to 6 - 8 lb.ft.
Important notes to remember during installation
1.
Re-connect the green squib connector to the matching green socket and the purple squib connector to the matching purple socket. Both squib
connectors are color coded and uniquely indexed to prevent cross-installation.
2.
Engage the secondary pin lock after you have completely inserted the connector into the appropriate connector housing. A 'click" sound should be
heard.
3.
After all electrical connections have been made and the new DAB module has been installed, re-connect the negative (-) terminal of the battery.
4.
Turn the ignition ON and confirm that the instrument panel air bag warning light turns OFF after approximately 6 seconds.
If the air bag warning light stays ON, erase any related trouble code using a scan tool. Then, re-check to confirm that the air bag warning light
turns off. If it does not, the SRS system must be diagnosed by following the procedures in the appropriate Tucson shop manual.
The original Driver Air Bag cover module must be destroyed and scrapped:
