Tucson AWD L4-2.0L (2007)
2.
To physically distinguish the 'NEW' DAB from the 'PREVIOUS' DAB, press the cover with both thumbs as shown above at a point approximately
20 mm (0.8 inch) below the 'H' logo. Previous DAB module covers will show an "I" shaped depression at the invisible tear seam, while the new
DAB module will show a 'T' shaped depression. Please refer to all of the photos.
3.
The new DAB cover module includes the black plastic air bag inflator opening shipping protection cover (A) and four inflator mounting nuts (B)
only. It does not include the inflator. Therefore, the existing inflator must be reinstalled onto the new DAB cover module. Refer to the following
Service Procedure.
SERVICE PROCEDURE
1.
Remove the ignition key from the ignition cylinder.
2.
Disconnect the negative (-) terminal of the battery. Wait at least 30 seconds after disconnecting the battery cable before proceeding.
3.
Using a small flat blade screwdriver, remove the (2) covers from the left and right sides of the steering wheel. Take care not to scratch the covers
and any of the surrounding trim.
4.
Using a T40 Torx driver, remove the (2) driver air bag module mounting bolts.
Re-assembly tightening torque: 6 - 8 lb.ft.
