Tucson AWD L4-2.0L (2007)
Clockspring Assembly / Spiral Cable: Testing and Inspection
CLOCK SPRING REPLACEMENT
1. Disconnect the negative battery cable, and wait at least 30 seconds before beginning work.
2. Remove the DAB.
3. Remove the steering wheel.
4. After disconnecting the lock pins (A), disconnect the connectors (B).
5. Loosen the mounting screw (C), then remove the clock spring (D).
6. Installation: verify steering wheel is straight ahead and tires are straight ahead.
7. Center clock spring.
8. Install Clock spring, turn wheel to check for binding. Complete installation in reverse order of removal.
Rotate the steering wheel from lock to lock and recheck.
NOTE: After installing the clock spring, confirm proper system operation; Turn the ignition switch ON: the SRS indicator light should be turned
on for about 6 seconds and then go off.
