Tucson AWD L4-2.0L (2007)
NOTE: Measure the pinion preload through the entire stroke of the rack.
2. It the measured value is out of specifications, first adjust the yoke plug, then recheck the total pinion preload.
3. If you adjust the yoke plug but do not obtain the total pinion preload, check or replace the yoke plug components
TIE ROD SWING RESISTANCE
1. Rotate the tie rod severely ten times.
2. Measure the tie rod (A) swing resistance with a spring scale (B).
Standard value
3. If the measured value exceeds the standard value, replace the tie rod assembly.
CAUTION: Even if the measured value is below the standard value, the tie rod that swings smoothly without excessive play may be used. If the
measured value is below 4.3 N (0.9 lb.) [100 Nm (8.7 inch lbs.)], replace the tie rod.
BELLOWS INSPECTION
1. Inspect the bellows for damage or deterioration.
2. Make sure the bellows are secured in the correct position.
3. If the bellows are defective, replace them with new ones.
Disassembly
POWER STEERING GEAR BOX
DISASSEMBLY
1. Remove the tie rod end (A) from the tie rod (B).
