Tucson AWD L4-2.0L (2007)
2. If there is any play, loosen the wheel nuts slightly. Raise the front of the vehicle, and make sure it is securely supported.
3. Remove the front wheel and tire (A) from front hub (B).
CAUTION: Be careful not to damage the hub bolts (C) then remove the front wheel and tire (A).
4. Remove the split pin (A), then remove castle nut (B) and washer (C) from the front hub under applying the break.
5. Tighten the hub bearing nut by the following procedures.
a. Hub bearing nut must be fastened with a torque of 28 kgf-m and front hub must be rotated 3 times enough for secure placement of hub bearing.
b. Unfasten hub bearing nut until its tightening torque is 0 kgf-m.
c. Hub bearing nut must be fastened again with torque 20 kgf-m
d. Assemble split pin.
